| Product Name | 6 ports Gigabit Managed Industrial PoE Switch |
| Product Model | HR600-BTGM–42S |
| Interface | 4 x10/100/1000M copper RJ–45 ports, 2 x1000M SFP port ,1x Console |
| Network Protocols | Support IEEE802.3,IEEE802.3u,IEEE802.3z, IEEE802.3ab, IEEE802.3x, IEEE802.1d, IEEE802.1w |
| L2 (Layer 2 Switching) |
| Port management | Enable / disable port Speed, duplex, MTU settings, etc. Flow–control flow control setup Support port mirroring Support port access direction, VLAN image To support the port speed limit, Support port isolation settings Unknown unicast, multicast, broadcast storm suppression PD Alive Check (WatchDog) |
| Spanning Tree Protocol | Standard Spanning Tree (STP) 802.1d Rapid Spanning Tree (RSTP) 802.1w Multiple Spanning Tree (MSTP) 802.1s |
| Ring Network Protocol | ERPS |
| Link Aggregation | Support static manual aggregation, Support LACP dynamic convergence IEEE 802.3ad |
| VLAN | Support Port based VLAN and IEEE 802.1Q VLAN |
| IGMP snooping | Support static add / delete, Support v1/2/3 dynamic multicast listener |
| GMRP | supports GARP multicast registration protocol |
| MAC | Support static add / delete MAC address learning limit Support dynamic aging time settings |
| L3 ( Layer 3 Switching ) and Router Function |
| Interface configuration | Support virtual VLAN interface |
| ARP | Support check ARP |
| Router function | Static router |
| Extended Function |
| ACL | based on the source MAC, destination MAC, protocol type, source IP, destination IP, L4 port number Support time-range time management |
| QOS | based on 802.1p (COS) classification Based on DSCP classification Based on the source IP, destination IP, port number classification Support SP, WRR, DRR scheduling strategy Support traffic speed limit CAR |
| LLDP | supports LLDP link discovery protocol |
| Log | User login, operation, status, event log |
| User setting | Support add/delete user |
| Prevent attack | DOS defense Support for CPU protection, limited to send CPU message rate ARP binding (IP, MAC, PORT binding) |
| system management | User add / delete user User login, operation, status, event log Device reset, configuration save / restore, upgrade management, time setting, etc. |
| Management Function |
| CLI | support serial command line management |
| TELNET | support serial command line management |
| SSH | supports SSHv1/2 remote management |
| SNMP | support v1/2/3 |
| ColdStart, WarmStart, LinkDown, LinkUp |
| WEB | supports two layers, three layers of view, etc. |
| Other Parameters |
| PoE Specification | PoE Standard: Supports both IEEE802.3af and IEEE802.3at |
| Single PoE Port Power Output: Max. 15.4 watts (IEEE 802.3AF) Max. 30 watts (IEEE 802.3AT) Max. 60/90 watts (IEEE 802.3BT) |
| PoE port Auto detect AF/AT/BT devices |
| PoE Port Output Voltage: DC48V (BT:12– 36+;45+ 78-) |
| Network Media | 10BASE-T: Cat3,4,5 UTP(≤100 meter) 100BASE-TX: Cat5 or later UTP(≤100 meter) 1000BASE-TX: Cat6 or later UTP(≤100 meter) |
| Fiber Media | Multi–mode: 1310nm, 2Km Single–mode: 1310nm, 20; 1550nm, 60/80/100/120Km |
| Performance Specification | Bandwidth: 24Gbps Packet Buffer Memory:4M Packet Forwarding Rate:1488000pps/port Address Table: 8K MTBF:100,000 hours |
| Forwarding Mode | Store-And–Forward |
| LED Display | Fiber Run indicator: G5,G6 Power supply indicator: PWR System indicator:SYS PoE ACT indicator: LED-Yellow 1000M LINK indicator: LED-Green |
نقد و بررسیها
هنوز بررسیای ثبت نشده است.